Sylglas
Anti-Slip Self-Adhesive Tape 
 
Size: 
50mm (width) x 3m (length)
 
Available in: 
Black
Yellow
Clear
Hazard (Black & Yellow)
 
Select your required type from option menu.
 
The perfect slippery surface tape.
 
Sylglas self adhesive Anti-Slip tape offers reduced risk of slips on potential slippery surfaces at home and the workplace.
 
Easy to apply it offers an excellent bond on most surfaces and can be used indoors or outside. 
 
 
Safety Facts:
One slip or trip accident occurs every 3 minutes and 95% of major slips result  in broken bones.
 
Sylglas Anti-Slip Tape can help to reduce accidents around  the home or garden.
 
Everyone has steps or pathways and even decking areas around the house where people can potentially slip and lose their footing.
 
Suitable for smooth surfaces only. Not suitable for grooved decking, the tape must be in full contact with the surface it is to be applied to, across the complete width of the tape with no gaps or voids
 
The elderly, disabled and children are more at risk of slips and trips leading to serious injuries in some cases, if no action is taken.
 
 
Ideal slip prevention for:
Steps, paths and all potential slippery surfaces, Patios, Decking areas, Garages, Metal Staircases & Invalid Ramps.
 
 
How to use:
Store the tape in warm dry conditions until ready for use. Ensure the surface is above 10°C and is clean, dry and free from any contamination or greasy residues, all porous surfaces should be sealed prior to application using a good quality undercoat or emulsion paint.
 
N.B. Allow the undercoat to dry, if applied, completely before applying tape.
 
Measure the area the tape is to be applied to and cut to length. Rounding off the corners of the tape may extend the products life; this should be done before applying the tape to the surface and with the release paper intact.
 
 
1. Peel back 50mm of the release liner and firmly press the adhesive side of the tape onto the prepared surface.
 
2. Progressively remove the remainder of the release liner and apply the tape, ensuring not to contaminate the adhesive surface with dust or finger marks during this process.
 
3. Do not stretch or tension the tape, press down firmly using even pressure, a hand roller may be used for this purpose. On steps and nosing’s set back at least 12mm from the edge to prevent premature wear.
 
 
The tape can be walked on immediately and will be fully bonded after 48 hours.